2.4. Transport damage
The unit shall be unpacked and checked for damage that might have occurred in the course of
transport. In case of such damage, the seller (sales representative, final vendor) or the
manufacturer of the unit shall be informed immediately.
3. Placement of the
device
During the installation, make sure that the following conditions have been met:
the floor, on which the unit will be placed, shall be horizontal and flat,
the case shall not be placed near sources of heat, such as: radiators, heaters, or
spot-light projectors,
the cabinet shall not be exposed to direct
sunlight .
If necessary, blinds/roller blinds in windows shall be applied.
air flowing from air conditioners or integrated ventilation systems ininteriors
shall not be directed at the device.
In case of devices with a built-in refrigerating unit, remember to provide air to
the evaporator (it cannot be covered),
keep the minimum distance according to the parameters: A=80 cm.
To Next Page
Loading...