ATTENTION: All sequencing actions may be carried out only by
suitably qualified personnel.
Attention: The manufacturer shall not be responsible for damages
occurring from inappropriate connection of the unit to the installation.
3.1. Placing the devices in a
sequence
In the case of a multicooler, it is possible to sequence the devices. The devices are placed
by pulling successive units to one another in any configuration of modules.
3.2. Assembly and
installation
The device is provided with a refrigerating unit and is not available in the version for an
external unit. In order to ensure correct operation of the device, it is recommended to connect
it according to the diagrams and guidelines presented below.
Attention: All installations shall be completed by the manufacturer or
qualified personnel.
Attention: All installations shall be connected out upon
disconnection from power source.
3.2.1. Electrical system
Lightning symbol inside a triangle on yellow background, which is
located on the body or the cover of electrical system, indicates the
230V voltage inside.
Only personnel qualified in the range of installation and repair of electrical systems receives
access to the live items.
Devices equipped with internal refrigerating unit
Prior to connecting the device it is necessary to check if the value of power voltage in the grid
and the quantity of required overload protection (a fuse) corresponds to properties indicated
in the table or in the rating plate that has been placed on the body of the device.
To Next Page
Loading...