4.1. Preparatory works for the first start-up
Before the first use, the device shall be thoroughly cleaned outside and
inside with a mild detergent.
ATTENTION: Make sure that all applied washing agents are non-
toxic and non-caustic!
Upon completion of washing, carefully dry all surfaces and empty the water container
as well.
4.2. Start-up
ATTENTION: Before the start-up of the device after its transport and
positioning in the intended place, wait 60 minutes.
Devices equipped with internal refrigerating unit
Check if the power cable is not damaged.
Turn on the main switch of the electrical system.
Change over all switches located in control box and in lighting panel into „I”
position.
Cooling devices: refrigerating unit , fans,
lighting and anti-condensation heaters shall be started-up.
4.3. Product display
Be careful in the course of stocking up.
Do not throw goods into the display case.
Do not exceed the load limit. Maximum load of the display area is shown in a table
with technical specifications of the device.
Products must be placed with at least 10 mm spaces between them on the isplay area.
Products shall neither protrude from shelf edges nor cover air inlets and outlets.
Guidelines related to the height of stock in the cabinet (covering air inlets is
forbidden) shall be observed. Inappropriate stock replenishment may cause
disturbance to air circulation inside the unit. This may subsequently cause disturbances
against correct operation of the unit.
To Next Page
Loading...