© ESAB AB2011
- 6 -
bh40d1e
Dispose of electronic equipment at the recycling facility!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical and/or
electronic equipment that has reached the end of its life must be disposed of at a
recycling facility.
As the person responsible for the equipment, it is your responsibility to obtain
information on approved collection stations.
For further information contact the nearest ESAB dealer.
ESAB can provide you with all necessary welding protection and accessories.
2 INTRODUCTION
Arc 180 and Arc 200 are welding power sources intended for use with coated
electrodes (MMA welding) and TIG welding (Live Arc).
ESAB's accessories for the product can be found on page 17.
2.1 Equipment
The power source is supplied with:
3 meter welding cable with electrode holder
3 meter return cable with return clamp
instruction manual.
3 TECHNICAL DATA
Arc 180 Arc 200
Mains voltage 230 V 1∼ $10%, 50/60 Hz 230 V 1∼ $10%, 50/60 Hz
Primary current I
max
36 A 40.7 A
Setting range MMA 5 A / 20.2 V - 180 A / 27.2 V 5 A / 20.2 V - 210 A / 28.4 V
Setting range TIG 5 A / 10 V - 180 A / 17.2 V 5 A / 10.2 V - 210 A / 18.4 V
Permissible load at MMA
30 % duty cycle
35% duty cycle
60 % duty cycle
100 % duty cycle
180 A / 27.2 V
130 A / 25.2 V
100 A / 24.0 V
200 A / 28.0 V
135 A / 25.4 V
120 A / 24.8 V
Permissible load at TIG
35% duty cycle
60 % duty cycle
100 % duty cycle
180 A / 17.2 V
130 A / 15.2 V
100 A / 14.0 V
200 A / 18.0 V
135 A / 15.4 V
120 A / 14.8 V
Power factor at maximum
current
0.72 0.71
Efficiency at maximum current >80 % >80 %
Open-circuit voltage U
0
max 59.8 V 66.3 V
Operating temperature -10 to +40° C -10 to +40° C
Transportation temperature -20 to +55° C -20 to +55° C
Sound pressure at no-load <70 db (A) <70 db (A)
Dimensions lxwxh 310 x 140 x 230 mm 360 x 140 x 230 mm
Weight 6 kg 7.5 kg
Enclosure class IP 23S IP 23S
Application class
GB
To Next Page