ESAB ESABMig C240 - TECHNICAL DATA; Equipment Supplied; Technical Specifications

− 5 −
C240e
3 INTRODUCTION
ESABMig C240 & ESABMig C240s are step controlled power sources in a compact design, intended
for welding with solid steel, stainless steel or aluminium wire as well as tubular wire with or without
shielding gas.
The possibility of welding with homogeneous wire/shielding gas and welding with gasless tubular wire
is obtained by switching the + and − connections on the switching terminal above the wire feed unit.
ESAB’s accessories for the product can be found on page 19.
3.1 Equipment
The power source is supplied with:
S Welding gun PSF 250 − 3m
S Return cable 3,5m with return clamp
S Shelf for gas cylinder
S Instruction manual
4 TECHNICAL DATA
ESABMig C240 ESABMig C240s
Voltage 230/400−415V, 3∼ 50/60Hz 230/400−415V, 3∼ 50/60Hz
Permissible load at
100% duty cycle 130A 130A
60 % duty cycle 170A 170A
30 % duty cycle 240A 240A
Setting range (DC) 20A /15V−240A / 23,0V 20A /15V−240A / 23,0V
Open circuit voltage 14 − 32V 14 − 32V
Open circuit power 190W 190W
Efficiency 76% 76%
Power factor 0.95 0.95
Control voltage 42 V, 50/60Hz 42 V, 50/60Hz
Wire feed speed 1,9 − 19m/min 1,9 − 19m/min
Burnback time 0 − 0,25s 0 − 0,25s
Spot welding 0,2 − 2,5s 0,2 − 2,5s
Creep start − + (auto)
2/4 stroke & motor inching − +
Welding gun connection EURO EURO
Wire dimension range 0,6 − 1,0mm 0,6 − 1,0mm
Max diameter of wire bobin 300mm 300mm
Dimensions lxwxh 840x425x830 840x425x830
Weight 94 kg 97 kg
Operating temperature −10 ÷ +40
o
C −10 ÷ +40
o
C
Enclosure class IP 23 IP 23
Application classification
GB