How to properly connect the torch to the power supply of my ESAB HandyPlasma 35i Cutter?
If the torch is not properly connected to the power supply of your ESAB Cutter, reinstall the torch. Check if the burner is completely installed in the burner female adapter and turn the burner plastic nut clockwise to fix it in position.
What to do if the ESAB Cutter power supply work cycle has been exceeded?
If your ESAB Cutter's power supply work cycle has been exceeded, it might be due to blocked airflow. Ensure that you leave the power supply on to let it cool down, and wait until the Overheating Error Screen closes before starting to cut. Also, maintain the ventilation gap and check if the fan operates when the main switch is ON.
Why is the main supply voltage for my ESAB HandyPlasma 35i Cutter not within the interval?
If the main supply voltage for your ESAB Cutter is not within the correct range, it might be due to a power supply component failure. Check if the input voltage is within the range of 204~276 V.
What to do if the input air pressure is too low or too high in my ESAB Cutter?
If the input air pressure for your ESAB Cutter is too low or too high, it might be because the gas line contains impurities. Adjust the input air pressure to 6 bar~8 bar. Also, disconnect the gas hose from the rear of the power supply or feeder and blow out any impurities. Check for gas leakage between the gas valve and the gas input or cylinder output.
General| Input Voltage | 230 V |
|---|---|
| Input Frequency | 50/60 Hz |
| Rated Input Current | 16 A |
| Output Current Range | 10 - 35 A |
| Rated Output Current | 35 A |
| Max Cutting Thickness (Mild Steel) | 12 mm |
| Max Cutting Thickness (Stainless Steel) | 8 mm |
| Cutting Capacity (Recommended) | 8 mm |
| Cutting Capacity (Severance) | 12 mm |
| Protection Class | IP23 |
| Duty Cycle | 60 % |
| Air Pressure | 5.5 bar |
To Next Page
