ESAB REBEL EMP 205ic AC/DC User Manual

8 MAINTENANCE
0463 703 001GB
-59-
8 MAINTENANCE
!!
WARNING!
Disconnect the electrical power source from the unit.
CAUTION!
Do not remove panels. User access is limited to only persons with the appropriate
electrician skills (authorized personnel) can remove safety plates for wire/spool
maintenance.
CAUTION!
The product is covered by a manufacturer’s warranty. Any attempt to carry out repair
work by unauthorized service centers will invalidate the warranty.
NOTE!
Additional maintenance should be performed if you operate in severe dusty condition.
NOTE!
There are no user serviceable parts inside of the power supply side of the EMP unit.
Any need for service on the power supply side should be referred to the nearest ESAB
service center.
8.1 Routine maintenance
Maintenance schedule during normal conditions:
Interval Area to maintain
Every 3 months
Clean or replace unreadable
labels
Clean weld terminals
Check or replace weld
cables
Every 6 months
Clean inside equipment.

ESAB REBEL EMP 205ic AC/DC Specifications

General

Input Voltage	120/230 VAC
Output Range	5-240 A
Duty Cycle	25% @ 205 A
IP Rating	IP23S
Welding Processes	MIG, Flux-Cored, Stick, TIG
Wire Diameter Range	0.6-1.2 mm
Dimensions	584 x 229 x 406 mm