ESAB Warrior Feed 304 - Introduction; Product Overview; Included Equipment

2 INTRODUCTION
0463 363 101
- 8 -
© ESAB AB 2019
2 INTRODUCTION
2.1 Overview
The Warrior Feed 304, Warrior Feed 304w wire feed unit is intended for MIG/MAG-welding
together with welding power sources:
• Warrior 400i CC/CV
• Warrior 500i CC/CV
They come in different variants, see chapter "Order Number".
The wire feed units are sealed and contain four-wheel drive wire feed mechanisms as well as
control electronics.
They can be used together with wire from ESAB's MarathonPac, or from wire bobbin
(standard Ø 200 mm, Ø 300 mm and accessory Ø 440 mm).
The wire feed unit can be placed on a trolley, suspended above the workplace with a lifting
eye, on a counter balance or on the floor with or without wheel set.
ESAB accessories for the product can be found in the "ACCESSORIES" chapter of
this manual.
2.2 Equipment
The Warrior Feed 304, Warrior Feed 304w wire feed unit is supplied with:
• Instruction manual
• Sticker with recommended wear parts