7
Kongsberg XN / iPC 2.0
30
7. Basic Operations
Keep away from Moving Parts during operation.
Do not lean on Racks, Guide Ways or Traverse during operation, as this may
cause personal injury.
Before starting any operation, make sure that:
• The Table is free from obstructions
• No unauthorized personnel come close to the table
7.1 Power On Sequence
Ensure the table is free from obstructions and ready for operation.
Follow these steps to power up the system and get ready to work:
1 Front End PC
Switch on the PC and the monitor.
2 Table Power
Switch the table on using the Main Power Switch.
Note: After power off, wait minimum 5 sec. before the system is
switched on again.
3 iPC
From Desktop, double-click the icon for iPC
Check that no error message indicates faulty conditions.
4 Safety System
Reset the Safety System by pressing the Pause pushbutton.
5 Servo Power
Press the Servo On pushbutton.
The Warning Lamp on top of the Y carriage should be on without
flashing.
To Next Page
Loading...
Need help?
General
