Esoteric N-01XD - Setting Mode Navigation; Accessing and Changing Settings

15
English
Setting mode
3 Use the setting adjustment (l/;) buttons to
change the settings.
To change multiple items, repeat steps
2
and
3
.
4 Press the INPUT button to end setting mode.
Setting mode will also end and the ordinary display will reappear
if nothing is done for ten seconds.
o Settings are retained even if the power plug is disconnected.
The settings for this unit are divided into three groups: Settings1,
Settings2 and Settings3.
The Settings1, Settings2 or Settings3 group will be shown depend-
ing on how the MENU button is pressed.
1
4
2
3
Changing settings
1 When stopped or during playback, press the
MENU button.
Settings1 will be shown.
To show Settings2, press the MENU button again for at least two
seconds while Settings1 is shown.
To show Settings3, press the MENU button again for at least two
seconds while Settings2 is shown.
2 Press the MENU button repeatedly to select the
item to change.
Each time you press the MENU button, the item shown on the
display changes as follows.
Settings 1 Settings 2 Settings 3
UPC>
c
CLK>
c
PCMG>
c
AOUT>
c
DIMMER>
c
DPaOFF>
c
APS>
PCMM>
c
DSDF>
c
LanLED>
c
NETin>
c
REMOTE>
AUD UPDATE>
o If you do nothing for ten or more seconds, setting mode will
end and ordinary display will resume.
However, setting mode will not end when Settings 3 AUD_
UPDATE is in use.
o Depending on the selected source and operation status,
some items might not appear.