Need help?Do you have a question about the ESP aperta EZTAG3 and is the answer not in the manual?
Diagram illustrating wiring for an electro-magnetic lock and an electronic lock.
Diagram showing wiring for two locks, push buttons, and door bell facility.
Step-by-step guide for configuring access PINs with keypad indications.
Instructions for registering proximity tags, including location numbering and batch registration.
Procedure for removing existing access PINs or registered tags from the system.
Steps to modify the 4-digit programming code for system access and configuration.
Process to erase all stored PINs and tag data, returning the system to a clean state.
Instructions to reset the device to its original factory configuration and default settings.
Configuring the duration for which Lock 1 remains active after a valid entry.
Activating the door bell function, allowing the keypad to act as a doorbell button.
Setting up the tamper alarm to activate the internal buzzer and external output upon unauthorized access attempts.
Procedure for assigning an access PIN to control the second lock output.
Steps to remove an access PIN specifically associated with the second lock output.
Setting the duration for the Lock 2 output to remain active after successful authentication.
Methods for unlocking Lock 1 using a programmed PIN or a registered tag.
Procedure to enter the system's programming mode using a default PIN or tag.
General| Brand | ESP |
|---|---|
| Model | aperta EZTAG3 |
| Category | Intercom System |
| Language | English |
To Next Page
