Need help?Do you have a question about the ESP EZ-LOCK and is the answer not in the manual?
Lists the necessary components for controlling one door, including power supply and locks.
Outlines the capabilities of the EZ-LOCK, such as controlling two doors and programmable features.
Guidance on optimal placement and step-by-step physical installation of the keypad.
Details the connections for power, inputs, outputs, and specific components like reed switches.
Specific wiring instructions for connecting the EZ-LOCK to a Maglock.
Specific wiring instructions for connecting the EZ-LOCK to a Yale type lock.
Procedure for accessing and leaving the system's programming menu using PIN.
Steps to program user PINs for up to 1000 locations in Zone 1.
Configures the door unlock duration for Zone 1, from 00 to 99 seconds.
Steps to program user PINs for up to 10 locations in Zone 2.
Configures the door unlock duration for Zone 2, from 00 to 99 seconds.
Procedure to change the master programming PIN for system access.
Instructions for deleting all PINs or specific PINs from Zone 1 and Zone 2.
How to load factory defaults or reset a lost programming PIN.
How to enable or disable the rear tamper monitoring and door bell features.
Configures the required length for user PINs and enables/disables the door bell.
Details key technical parameters including input voltage, current, temperature, and dimensions.
To Next Page
General