ESP EZ-LOCK - Programming the EZ-LOCK System; Entering and Exiting Programming Mode; Zone 1 Programming

Brief details of programming
Access To programming mode.
Programme pin numbers.
There are two locations for entering pin numbers (zone 1 and zone 2).
Zone 1 has 1000 locations available 000-999.
Zone 2 has 10 locations available 00-09.
Select the lock release times (00-99 seconds) zone 1 and zone 2.
How to escape programming mode.
Note:- if no keys are pressed for 30 seconds the unit will drop out of
programming mode automatically.
How to enter and exit programme mode
• To enter programme mode enter the 4 digit pin number twice
(default pin 1234).
• To exit programme mode press the # key.
Zone 1 programming
Programming a User Pin number to Zone 1
Note:- Zone 1 has 1000 locations available from 000 to 999.
1. Enter programming mode
A Long bleep will be heard and the green power LED will turn orange.
2. Enter the vacant location you want to programme the pin
number in use a 3 digit format (xxx).
The green programming LED (top left of keypad) will illuminate.
Note:- if this location already has a pin number programmed the LED will
turn red.
To delete this location press the star
*
key twice. The LED will now turn
green.
3. Enter the pin number required, a conformation bleep will be
heard.
If further pin numbers are to be programmed select the next available
location number (xxx).
6
EZ-LOCK Manual_Layout 5 04/04/2013 14:53 Page 6