ESP EZ-LOCK - Factory Default Settings and PIN Reset; Tamper and Door Bell Functions

9
How to load factory default settings
1. Enter programming mode.
A Long bleep will be heard and the green power LED will turn orange.
2. Press the
*
key followed by the 8 key the orange LED will start
to flash.
3. Press the 9 key twice.
One bleep will sound and the System will automatically come out of
programming mode.
How to Disable the rear tamper
1. Enter programming mode.
A Long bleep will be heard and the green power LED will turn orange.
2. Press the
*
key followed by the 6 key the orange LED will start
to flash.
3. Press the 0 key followed by the 1 key.
The rear tamer is now off.
How to Enable the rear tamper
1. Enter programming mode.
A Long bleep will be heard and the green power LED will turn orange.
2. Press the
*
key followed by the 6 key the orange LED will start
to flash.
3. Press the 0 key followed b
y the 2 key.
The rear tamer is now on.
EZ-LOCK Manual_Layout 5 04/04/2013 14:53 Page 9