ESPEC EHS-211M - Setting Commands; To Switch to the Constant Mode; To Switch to the Program Mode

Chapter 3 Commands
3.3 Setting Commands
Setting commands have the below format.
Address, main command [, optional parameter] , setting data
■To Switch to the Constant Mode
Table 3.26 Constant mode setting command
Setting command
Address
Main
command
Optional
parameter
Setting
data
Description/Setting data format/Example command
＜
Description
＞
Switches operation to the constant mode.
＜
Setting data format
＞
“CONSTANT”
1 to 16 CONSTANT
−
Operating
mode
＜
Example command
＞
“1,CONSTANT”
■To Switch to the Constant Mode
Table 3.27 Constant mode setting command
Setting command
Address
Main
command
Optional
parameter
Setting
data
Description/Setting data format/Example command
＜
Description
＞
Switches operation to the constant mode.
＜
Setting data format
＞
“CONSTANT”
1 to 16 NORMAL
−
Operating
mode
＜
Example command
＞
“1,NORMAL”
■To Switch to the Program Mode
Table 3.28 Program mode setting command
Setting command
Address
Main
command
Optional
parameter
Setting data
Description/Setting data format/Example command
＜
Description
＞
Switches operation to the program mode.
＜
Setting data format
＞
“PROGRAM”
1 to 16 PROGRAM
−
Operating
mode
＜
Example command
＞
“1,PROGRAM”
33