ESPEC EHS-221 - To Monitor Program Mode Current Step no; To Monitor Program Mode Pattern no; To Monitor Program Mode Setup

Chapter 3 Commands
■To Monitor Program Mode Pattern No.
Table 3.14 Program mode pattern No. monitor command
Monitor command
Address
Main
command
Optional
parameter
Description/Example command/Response format/Example
response
＜
Description
＞
This command requests the chamber to return the current pattern
No. being used in the program mode.
＜
Example command
＞
“1,PPAT?”
＜
Response format
＞
“pattern No.”
1 to 16 PPAT?
−
＜
Example response
＞
“1”
■To Monitor Program Mode Current Step No.
Table 3.15 Program mode current step No. monitor command
Monitor command
Address
Main
command
Optional
parameter
Description/Example command/Response format/Example
response
＜
Description
＞
This command requests the chamber to return the current step No.
being run in the program mode.
＜
Example command
＞
“1,PSTP?”
＜
Response format
＞
“step No.”
1 to 16 PSTP?
−
＜
Example response
＞
“1”
■To Monitor Program Mode Setup
Table 3.16 Program mode setup monitor command
Monitor command
Address
Main
command
Optional
parameter
Description/Example command/Response format/Example
response
＜
Description
＞
This command requests the chamber to return the setup of current
step of program.
＜
Example command
＞
“1,PSET?”
＜
Response format
＞
“temperature,humidity,time,time signal 1,time signal 2”
1 to 16 PSET?
−
＜
Example response
＞
“105.0,100,0.0,OFF,OFF”
27