Getting Start
If your identity cannot be verified, you are prompted to try again,
the following appears:
It continues for about 0.5 seconds, return to the start-up window.
1: G; 1: H (Group authentication)
For group authentication, user can define a range of user ID, if user
ID is within the range, authentication way must be 1: N, otherwise
the authentication procedure is 1:1 matching.
--1: H authentication: user must input the advance part ID to
perform fingerprint authentication, if the input ID is entire No., the
system will carry on 1:1 authentication,
--1: G authentication: the user must be grouped before
authentication, you can specify a group ID of 1--4 digits long for
each user group. You will enter a group ID and press down -key,
and then place a fingerprint for authentication. You can specify a
group ID when you register a user. Unlike other methods, you must
FP Verify
Enroll No 00001
Verified！
FP Verify
Place Finger Agn！
To Next Page
Loading...
