- 25 -
If your identity cannot be verified, you are prompted to try again,
the following appears:
It continues for about 0.5 seconds, return to the start-up window.
（2）1：N authentication (Identification)
Only enrolled fingerprints are used for authentication. Though the
authentication procedure is simple, this method will take a little
longer than the 1:1 authentication if there are many users. There is
no need to make any special settings in the system
Operational trip：
Place the finger on the sensor surface, the following appears:
It continues for about 0.5 seconds. If the test is successful, it will
say “Thank you”, the following appears:
FP Verify
Place Finger Agn！
FP Verify
Please Move Finger
To Next Page
Loading...
