- 45 -
n Firmware Upgrade: if want to upgrade the firmware of
machine, may use the USB flash disk or connect the machine
to the PC, carry out the operation process.
Caution: The user does not random upgrade the firmware,
you must be allowed by the dealer before to upgrade the
firmware, voluntarily upgrade occur the question which
possibly affect your normal use.
n No. Card：This item is set as “Yes”, only verify No. card to
pass authentication. If this item is set as “NO”, after verifying
Card, must go on fingerprint verification.
n R.Card Only：This item is set as “Yes” must register card on
the fingerprint machine first; if this item is set as “No”, need
not to register card.
n FPCard Key：After this item is set, the fingerprint machine
will be able to write in password to the card which has been
register in the fingerprint machine.
n Remote：After this item set as “Yes”, this fingerprint machine
can be used in Remote Identification mode.
There are four mode to select (NL, LN NO, LO) in the
fingerprint machine, these option signify different thing,
NL, indicate that firstly perform network verification then
local verification,
LN, first perform local verification then go on network
verification,
To Next Page
Loading...
