EST SFS1-CPU - Regulatory information; Contact information

8 / 8 P/N 3101773-EN • REV 04 • ISS 05AUG13
Signaling line circuit
See the 3-SDC1 Signature Data Circuit
Card Installation Sheet (P/N 3101772-ML)
FireWorks communication
See the FireWorks UL5 Workstation
Installation Manual (P/N 3101492-
EN) and
MN-COM1S RS-232 to Ethernet Interface
Installation Sheet (P/N 3101492-EN)
Building management
system
communication
See the FSB-PC2 and FSB-PCLW
Communication Bridge Installation Sheet
(P/N 3102007-EN)
Wire size
12 to 18 AWG (2.5 to 1.0 mm²)
Ground fault impedance
10 kΩ
Operating environment
Temperature
Relative humidity
32 to 120°F (0 to 49°C)
0 to 93% noncondensing
Note:
For battery calculations, standby and alarm currents include all
listed primary power supplies.
Regulatory information
Manufacturer
Edwards, A Division of UTC Fire & Security
Americas Corporation, Inc.
8985 Town Center Parkway, Bradenton, FL
34202, USA
Year of
manufacture
The first two digits of the date of manufacture
(located on the product identification label) are
the year of manufacture.
FCC compliance
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
Environmental
class
UL: Indoor dry
Contact information
For contact information, see www.est-fire.com.