EN - 45
EN
5. VACCUM CLEANER USE
Note
The vacuum cleaner has voice notifications that are set to Czech at the factory.
5.1 SWITCHING ON THE VACUUM CLEANER
1. Press the C1 button.
2. After the system is loaded, an acoustic signal and a voice alert will sound (the C1 button
light will be permanently lit).
5.2 BATTERY CHARGING
1. Check that the charging station is properly connected to the mains.
2. Place the vacuum cleaner near the charging station and press the C2 button. If the
battery is too low, place directly and correctly the vacuum cleaner on the charging
station.
Notes
• Standard charging time is approx. 3-4 hours. Fully charged battery will work for
approx. 120 minutes, depending on set functions.
• The stated operating times are based on ETA‘s internal testing and only apply to
a new and fully charged battery. Depending on the age and wear of the battery, the
operating time decreases.
• If you do NOT intend to use the vacuum cleaner for a long time, remove the battery.
• After cleaning, the vacuum cleaner will automatically search for the charging station.
• The "ETA SMART" application makes it easy to find out the battery status. The
application can also be sent back to the charging station at any time.
To Next Page
Loading...
Need help?
General
