ENGLISH
19
Relay ou tp ut s
You may set three relay outputs
independently, associated respectively to:
• PUMP_1 (pH), or Chlorine
• PUMP_2 (Rx), or else pH, depending on
the model
• TIMER
• TEMPERATURE
Refer to fig. 9 for the connection of the
relays. By default, RELAY 1 is associated to
Pump_1, RELAY 2 to Pump_2 and RELAY 3 to
the TIMER. The timer of the relay function is
independent from the timer function
described in the following paragraph. There
are however four daily cycles, or else 4
cycles for each day of the week.
It is possible to decide whether to enable
the relay even in the absence of ow (default
DISABLED)
To Next Page
Loading...