4 Real time programs
Real time programs
Part of setting the conditions under when your real time program will run,
you were able to specify days of the week. Now, in version 3.1 software,
you can specify a particular date instead.
Creating real time programs
The procedure and two sub-procedures below replace the two
procedures given under Creating real time programs under Control
Interfaces in your User Manual. The following procedure sets specific
days of the week and absolute times. If you prefer to cite a specific date
rather than days of the week or referencing sunrise/sunset times rather
than absolute times, substitute using the sub-procedures provided.
Footnotes to this procedure explain where to make those substitutions.
Set a date or days of the week.
Keystrokes:
Action:
1. Press [Setup].
Selects Setup display mode
2. Press [1][2] [Enter].
Selects Real Time Programs display
3. Press [S1], Select
Program, [1] [Enter].
Prompt reads:
Enter time (12 hour clock)
Press [+] to enter AM or PM
4. Press [8][0][0] [Enter].
a
a) To reference sunrise or sunset rather than absolute time,
substitute the steps under Referencing sunrise or sunset, page 5,
for step 4. Then continue in this procedure.
Enters time to run macro.
Prompt reads:
Enter days of week (1=Mon, 2=Tue,
3=Wed, 4=Thu, 5=Fri, 6=Sat, 7=Sun)
or press [Days/Date] softkey again
for date
5. Press [1] [And] [3] [Thru] [5]
[Enter].
b
b) To reference a date rather than days, substitute the steps under
Referencing a date, page 5, for step 5. Then continue in this
procedure.
Enters days to run macro
Prompt reads:
Enter macro number
6. Press [5] [Enter].
c
c) Labels are allowed in Express showfiles but cannot be assigned
there. To assign labels for Express showfiles, see Express LPC
autocontrols, page 8.
Creates real time program 1
Prompt reads:
Type program label (F6 = clear to end,
F7 = previous program label,
F8 = next program label)
7. Enter a label, then press
[Enter].
Labels the real time program
To Next Page
Loading...
Need help?
General
