ETC Expression User Manual

8 Express LPC autocontrols
Express LPC autocontrols
Many new autocontrols have been created for the Express LPC.
Autocontrols enable you to access to software displays and make
settings. With the new autocontrols, you can set or change all but the
astronomic settings of the real time clock and ensure the compatibility of
remote interface devices used in a network with your LPC. Information
about each of these operations is given in the version 3.1 Express LPC
QuickGuide.
All autocontrols are executed with a 4-step procedure. For detailed
information about using autocontrols, refer to the Express LPC
QuickGuide.
An Express LPC with version 3.1 system software contains the following
autocontrols.
New autocontrols allow you greater access to
system software functions.
Autocontrol buttons Function
M7 / M1 Stage display
M7 / (M1 and M2) Plus
M7 / M3 Patch display
M7 / (M1 and M3) Enter
M7 / (M2 and M3) Minus
M7 / (M1 and M2 and M3) Clear
M7 / M4 Setup display
M7 / (M1 and M5) Reboot
M7 / (M5 and M6) Nothing
a
a) Convenience that enables you to back out of an
autocontrol operation without changing anything.
M7 / (M1 and M6) Softkey [S1]
b
b) Softkeys always apply to the existing display, as
viewed on your video monitor.
M7 / (M2 and M6) Softkey [S2]
M7 / (M3 and M6) Softkey [S3]
M7 / (M4 and M6) Softkey [S4]
M7 / (M1 and M5 and M6) Softkey [S5]
M7 / (M2 and M5 and M6) Softkey [S6]
M7 / (M3 and M5 and M6) Softkey [S7]
M7 / (M4 and M5 and M6) Softkey [S8]
M7 / (M1 and M2 and M3 and
M4 and M5 and M6)
Record
M7 / Read From Disk
Read system
configuration

ETC Expression Specifications

General

Brand	ETC
Model	Expression
Category	Controller
Language	English