24 SolaPix 37 User Manual
Access Service Settings
Navigate:Main Menu → Set → Service Setting
Parameter Value Description
Service PIN Service PIN XXX
You must enter the Service PIN in order to access the
other Service Setting parameters. The default Service
PIN is 050.
RDM UID
Manufacturer ID
and a randomly
generated number
This password-protected menu item lets you modify
the RDM UID. You must enter the Service PIN to
access this menu item.
Note:Remote Device Management (RDM) requires
that all RDM devices have a unique identifier (UID).
Modifying this setting can break the RDM capability of
this fixture.
Duplicate RDM UIDs on the same DMX control run will
result in a data collision, causing a communication
failure. Ensure that all fixtures have a unique RDM
UID if RDM functionality is to be used.
If DMX splitters are used and RDM control is to be
used, these splitters must support RDM.
Ethernet IP XXX.XXX.XXX.XXX
This password-protected menu item lets you modify
the IP address. You must enter the Service PIN to
access this menu item.
The default IP address is 002.142.058.034.
Ethernet MaskIP XXX.XXX.XXX.XXX
This password-protected menu item lets you modify
the IP subnet mask. You must enter the Service PIN to
access this menu item.
The default IP subnet mask is 255.000.000.000.
Clr Err Info
ON
OFF
This password-protected menu item lets you clear
error messages after you have fixed the errors. You
must enter the Service PIN to access this menu item.
Set this parameter to ON in order to clear the error
messages. The default setting is OFF.
Set the Fans Mode
Navigate:Main Menu → Set → Fans Mode Setting
Select the fan mode for the fixture:
Standard
Studio (reduces fan noise, but decreases fixture output by ~20%)
To Next Page
Loading...
