ETC HIGH END SYSTEMS SolaPix 37 - Test Menu

Configure the Fixture 25
Set Display Settings
Navigate:Main Menu → Set → Disp. Setting
Parameter Value Description
Shutoff Time 02–60 minutes
Enter the amount of time the fixture waits after the
last user interface button press until the display goes to
sleep. The default value is 5 minutes.
Flip Display
•
ON
•
OFF
Flip the display 180° when the fixture is mounted
vertically. The default value is OFF.
Shortcut: With the main UI window displayed, press
[>] to flip the display 180°. Press [<] to flip it back to
its original orientation.
Key Lock
•
ON
•
OFF
Lock the user interface. The default value is OFF.
To unlock the user interface buttons, press and hold
the [MODE/ESC] button for three seconds.
Set the Temperature Scale
Navigate:Main Menu → Set → Temp. C/F
Select the temperature scale for the fixture:
•
Celsius (default value)
•
Fahrenheit
Update Fixture Firmware Using the USB Port
Navigate:Main Menu → Set → USB Update
Fixture firmware updates are available on the High End Systems, Inc. website at highend.com.
1. Save the firmware update file to a USB drive.
2. Insert the USBdrive in the fixture base (see Fixture Overview on page4 for the USB port
location).
3. On the Main Menu, select Set → USB Update. The fixture reads the USBdrive and
displays a list of any firmware update files on the USB drive.
4. Select the appropriate file and then press the Enter button.
5. The software prompts you to confirm the update with the message "Update fixture?" Use
the navigation buttons to select "Yes," and then press the Enter button.
6. Remove the USBdrive from the fixture.
Reset Fixture to Factory Default Settings
Navigate:Main Menu → Set → Reset Default
Select ON to reset the fixture to the factory default settings.