ETC Setup and Connect Guide
Paradigm
®
Touchscreen Interface
Paradigm Touchscreen Interface Setup and Connect Guide Page 7 of 12 Electronic Theatre Controls, Inc.
Device Setup Tab
Common settings that are required to set up your Paradigm
®
Touchscreen Interface including the
Network Connection, IP Address, Subnet mask, Gateway, and Volume and Brightness Settings are
available on the “Device Setup” tab.
Network Adaptor and IP Settings
The “Network Adapter” status on the top of the screen indicates whether a valid Paradigm network is
Online or Offline.
The section for “IP Settings” provides TCP/IP v4 settings for the Touchscreen Interface.
• Network Connections - always defaults to “ETC Net3 Network” which is the only network the
P-TSI should be connected.
• Allows for either Automatic or Manual IP settings. Default setting is Manual (IP address:
10.101.18.101, Subnet mask: 255.255.0.0, Gateway: 10.101.1.1).
• Select Automatic when LinkLocal IP (no DHCP) or DHCP.
• Select Manual to manually set the IP address, Subnet mask, and Gateway IP of the
Touchscreen. With “Manual” selected, touch inside each field to set the numeric values.
Volume Settings
Adjust the volume and brightness settings using the provided sliders. To mute the volume for the
Touchscreen, select the “Mute Sound” checkbox beneath the Volume Settings slider.
Display Setting
Determine the sleep settings for the touchscreen display using the drop down selection box. By default
the display is set to turn off after 15 minutes without user interaction.
Note:
Save any changes before leaving this tab or the changes will be lost. Touch the
[Save Changes] button to save.
Note:
Save any changes before leaving this tab or the changes will be lost. Touch the
[Save Changes] button to save.
Note:
Save any changes before leaving this tab or the changes will be lost. Touch the
[Save Changes] button to save.
To Next Page
Loading...
