Need help?Do you have a question about the ETC Paradigm P-TS7 and is the answer not in the manual?
General| Brand | ETC |
|---|---|
| Model | Paradigm P-TS7 |
| Category | Touchscreen |
| Language | English |
Details high-resolution displays, touch sensitivity, and integration with Paradigm Architectural Control Processor (P-ACP) and ControlDesigner.
Explains symbols like Note, Caution, and Warning used to highlight important information and potential risks.
Provides contact information for technical support across different regions and troubleshooting steps.
Describes how P-TS7 touchscreens connect to the Paradigm control system via LinkConnect or NetConnect for power and data.
Details the I/O panel, including USB port, SD card slot, and indicator LEDs/service pins on different models.
Describes the labels and grouping of I/O panel buttons and indicators for Status, LON, and NET connections.
Explains that ControlDesigner software creates graphical layouts and page navigation features for the P-TS7 touchscreen.
Details how to access the Setup menu via the {Setup} or [Mode] button and the basic layout of setup pages.
Displays read-only information on touchscreen firmware and operation, including MAC/IP Address, Neuron ID, and firmware versions.
Provides user settings for touchscreen brightness, timeout, light sensor, and proximity sensor functionality.
Offers volume control for the master volume level of the touchscreen's built-in speaker.
Describes the {Test Touchscreen} button for testing touchscreen functionality, noting factory calibration.
Explains that certain pages/features require a passcode for access, typically during system commissioning.
Provides P-ACP connection info and secured access to Mobile App Settings for remote control.
Details enabling and configuring the touchscreen for the Remote App, including connection, passcode, and port settings.
Displays project info from ControlDesigner/LightDesigner, with access to Timed Events and Passcodes.
Explains adding, editing, and deleting timed events, noting it's a passcode-protected page accessed via Config.
Explains passcodes are required for protected Setup menu screens, with default Setup passcode 3031.
Provides configuration and theme file management, allowing load, save, delete, noting it's passcode protected.
Provides access to view/edit network address settings, including IP Addressing modes (Manual/Automatic).
Offers hardware info, options to Reload Firmware, Reset To Defaults, and view Event Log.
Instructions for cleaning the touchscreen display using a dry microfiber cloth, advising against chemicals.
To Next Page
