Lamp Socket Assembly 7
16: Install the bushing cup (5) into the housing socket casting (1) as shown in
Figure 6
. The cup
should slide smoothly up and down, but not side to side.
17: Insert the threaded end of the index hub (6) through the holes in the bushing cup and the back
of the housing socket casting (1).
18: Slide the X-Y knob (3) over the exposed index hub bolt (6), then insert the wave washer (14) on
the bolt and secure with the 9/16 hex nut (13). Hand tighten the X-Y knob (3).
19: Insert the knurled head screw (11) through the housing socket casting (1) as shown in
Figure 7
.
20: Install the shorter green ground wire (22) onto the screw. The prongs on the crimped connector
should be toward the casting.
21: Install the ground spring (21) onto the screw and secure it with the Southco flat retaining ring
(12). Install the Southco ring with its prongs away from the casting.
22: Lay the leads in the bottom half of the cable clamp (located in the housing socket casting [1]),
making sure that the fiberglass sleeving extends slightly past the screw holes in the housing
socket casting. Install new sleeving if necessary. Then, route the wires as shown in
Figure 8
.
23: Install the top half of the cable clamp (15) and secure it with the two screws (16). Tighten the
screws alternately to ensure a solid connection.
Note:
Install the wave washer with the upward curve toward the hex nut.
Note:
Use pliers to straighten the Southco retaining ring (12) if it bends when you install it
on the bolt.
CAUTION:
You must follow the wire routing diagram to ensure that the socket leads do
not interfere with the lamp focus mechanism.
11
15
1
22
21
12
Cable Clamp in
Housing
16
8
4
Figure 7 Figure 8
To Next Page
