-15-
In the MR state, need to press MEM key to exit the MR state,
then continue to measurement.
In setting Alarm Critical Value state, need to press the
POWER key or press the AL key for 3 seconds, exit Alarm Critical
Value state, then continue to measurement.
In the resistance test model, press A key to switch to current
test model.
5．Date Lock/Release/Storage
In test model, press HOLD key to Lock currently displayed
value and HOLD symbol. At the same time, this lock-values as a
set of data followed by auto-ID and store, and then press HOLD
key to cancel the lock, HOLD symbol disappeared, can continue
to measure. Loop operation, can store 99 sets of data. If the
memory is full, blinking display MEM symbol.
Figure 9，Lock measured resistance 0.016Ω, at the same time
as the first 01 sets of data storage.
*As indicated in Figure 10, lock the measured current 278mA, and
save it as data unit No.99.
And the memory is full now.
blinking display MEM symbol.
In the Date Access Model, press MEM key to exit, then can
lock and storage the data.
In setting Alarm Critical Value state, need to press the
POWER key or press the AL key for 3 seconds, exit Alarm Critical
Value state, then can lock and storage the data.
Shutdown and then boot up, don’t lose stored data.
To Next Page
Loading...
