KL8-3H-CAA6/KL8-3H-BAA6
increased hours。The longest continuous working hours for 19 hours and 55 minutes。
After the time set to open access to the next step。
3、After all the settings and then click“ ”Button to confirm，the system automatically set the state
to withdraw from circulation cleaning (according to“ ”To give up the keys and the eject button)。
***Note***
1、 Circulation cleaning all the settings must be in the standby mode.
2、 In the entire set up process, the circulating pump and ozone will not work.
5、Pre-heat settings:
Can only be set once a day pre-heating，Whether or not to start pre-heating? In the LCD can be
at a glance。 See the figure below：
ON
OFF
Figure 7： Pre-heating is turned on Figure 8： Pre-heat the closure of
All the settings of pre-heating must be in the waiting state，at this time will be displayed on the LCD“-
- -”。
1）、By“ ”Key，set the state to enter the pre-heating，when the LCD on the “ON” signs indicate
that“PREHEAT”Flashing signs will appear，At the same time，one clock time（pre-heating start working
time）is flashing too，but “：” no flashing（see Note 2）。Again“ ”Key，Closed set（see Note
1）。
To Next Page
Loading...
Need help?
General
