KL8-3H-CAA6/KL8-3H-BAA6
every time，working time is 30 seconds， ozone work for 15 minutes，15 minutes for clearance。
Water surf PUMPS and BLOWER is turned on，ozone can not work；circulating pump is turned
off，the ozone can not work。
13、 the bottom light steps:
The first by “ ” Key， to open the underwater lights，the color slowly changes； the second
time by “ ”， The color of the current fixed； the third time by “ ”，The closure of the
underwater lights。
14、constant temperature heating steps:
1), in the pre-heating time to the pre-heating case opened or by “ ” Key can be turned on the
heating system thermostat。
2）、When heating the normal opening for the time by “ ” Key to open the heater，the
circulation pump will work automatism。
3)、heating thermostat open， the furnace is turned on when the thermostat has been circulating
pump rotation。
4)、such as temperature set to 35 ℃， when the temperature reached or exceeded 36 ℃， the
heater shut down， 5 seconds after circulating pump will stop working (cleaning pump did not start the
case)； and when the water temperature at or below 34 ℃， circulating pump restart， and re-open the
heater。
15、the operation of blower:
Button “ ” Control of the wind pump on / off。
Blower is activated，as in the absence of circumstances， the work of 20 minutes will be
automatically closed。
16、Fahrenheit and Celsius temperature switch:
In the waiting state by “ ” Button，the temperature in Fahrenheit and Celsius temperature
switch。
17、when the pool water, the three-way water pump and thermostat systems are not
activated, but the LCD display on the corresponding symbol will be flashing.
18、Frozen preventing control function
When the water temperature below 5 ℃， the heater and circulation pump will automatically start
the water heating， when the water reached 10 ℃， the heating stopped。
This function must ensure that the normal power supply。
19、power control function（only of KL8-3H-BAA6）
There are one power control modes： PC1： the latter priority。
Power control all the high-voltage load is divided into two groups，one for A：heater + circulating
pump，and the other group B：surf pumps+ blower 。
1), PC1： the latter priority mode：
When opening Group A or B in any one of the load，and load a group of self-closing，such
as： open PUMP1，heater and circulating pump shut down automatically；the same token，open
the heating，The surfing pumps and blower shut down automatically。
2), Setting of power control mode：
To Next Page
Loading...
Need help?
General
