KL8-3H-CAA6/KL8-3H-BAA6
15 ~ 42 ℃。
5） After all the set and then click “ ” Button to confirm， the system automatically set the
status from the pre-heating。
*** Note ***
1, pre-heating of all the settings and work must be in the waiting state。
2, please refer to LCD is the display “ON” or “OFF”， shows “ON”， said pre-heating is
turned on when the pre-heating start working time and the current settings at the same clock，it will
start pre-heating。Shown as “OFF” at any time when it will not start pre-heating。
3, set in the entire pre-heating process， the constant temperature furnace and water pump will
not start the work cycle。
6、pre-heating of the work:
When real-time clock and pre-heating setting start working time consistent，pre-heating is set to
“ON” and the bathtub with water，it will start the pre-heating。circulating pump and automatic
constant temperature system work at the same time，LCD display position on the countdown clock
time （“：” are no longer flashing）。
Work in the pre-heating process，when the end of the countdown time，the system automatically
shut down pre-heating； At this point you can also “ ” Closed pre-heating。
***Note***
1, when the temperature is too low (less than or equal to the water temperature)，although the
start of pre-heating，but the constant temperature furnace and the circulation pump will not start。
2, each state (no water、still water、flowing water) switching time of 30 seconds。
7、the work of circulation cleaning:
When the real-time clock and the setting start working time of circulation cleaning consistent，
the circulation cleaning is set to “on”（the mark“ ” of LCD panel is on）， and the bathtub
with water， it will start the circulation cleaning ，At this point LCD display on the part of the countdown
time clock（“：” are no longer flashing）。
All the surf PUMPS and BLOWER will activate，the working time is 30 seconds，Synchronized to
start circulating pump，Ozone after 15 minutes of each work will be shut down for 15 minutes。
In the course of the circulation cleaning， when the countdown to the end or “ ” Key to
close the cycle of cleaning。
8、on / off operation
In the waiting state by “ ” Key to enter the working state，State in the working state by
“ ” Can enter the waiting state，LCD display can be seen whether the state boot?
OFF
OFF
Figure 8：waiting state Figure 9：working state
To Next Page
Loading...
Need help?
General
