Euhomy CFL-25 - Brief Operating Instructions; Refrigerator opening and closing; Control panel locking and unlocking; Refrigerator temperature setting

05
Brief Operating Instructions
1. Refrigerator opening and closing:
Connect the correct DC 12/24V power supply. If the refrigerator is in standby mode, press
and hold the power button for 2 seconds to complete the startup. After startup, the display
will normally display information such as the current temperature and working mode of the
compressor. After the startup delay (1 minute preset by the factory), the refrigerator runs in
operating mode and the compressor starts refrigeration.
2. Control panel locking and unlocking:
If the control panel is locked (the Child Lock icon in the lower right corner of the display is on),
press and hold the up arrow and down arrow simultaneously for 2 seconds to release the lock. If
the Child Lock icon is not on and there is no operation for 20 seconds, the control panel will
automatically enter the locked state.
3. Refrigerator temperature setting:
When the keyboard is unlocked, press the up arrow or down arrow to adjust the temperature
of the refrigerator by 1 degree. (A group of temperature values on the display screen will flicker to
display the current setting value.) If you hold either arrow button, you can quickly set the desired
temperature value. If there is no change within 5 seconds, the set value will be saved automatically.
Press and hold the Settings button for 2 seconds. The temperature indicator will blink. You can
select the temperature unit with the up and down arrow buttons.
4. Compressor operating mode setting:
When the control panel is unlocked, press the Set button to switch the compressor working
mode between Eco and Max. If you need to quickly cool to a lower temperature, switch to the Max
mode. If you only need to refrigerate or store items that are already cool, you can set the Eco mode
to save power.
5. Low voltage-protection function setting:
This product has a low voltage-protection function. When it detects that the battery
voltage is lower than the set value, it will automatically turn off the compressor to avoid damaging
the battery or preventing the car from starting normally. At this time, the display screen will display
code E1. If the voltage returns to normal, the refrigerator will automatically enter its working state
within 1 minute. The factory default is M (medium). If you need to change it, please follow these
steps:
a. Unlock the control panel.
b. Long-press the Set button for 6 seconds. Release it after you hear a beep. Then press the Set
button for a short time. At this time, one of the battery protection-level icons (V, V=, V=) on the
display will flash. Press the up or down arrow to change the set specific value.