Operation & Installation
This portable ice maker uses a fully automatic control system with an advanced microcomputer for
easy and convenient ice-making. Simply add water, plug into an outlet, and press the Power
button. You can select one of two ice-cube sizes with the touch of a button.
The ice maker will stay idle for 3 minutes when you first use it or in ice-making cycles. We suggest
you discard the ice cubes made in the first four cycles to ensure that the machine is clean. Warning
indicators will alert you to add water when the tank is empty and to remove ice when the storage
basket is full. The ice maker also has built-in safeguards that shut down the system automatically
when needed to limit accidental damage.
The incline of the ice-maker cabinet should not exceed 45 degrees during transportation or use.
Do not turn the ice maker upside down; doing so could cause the compressor or refrigerating
system to operate incorrectly. When the ice maker is moved or transported, please allow time for
the fluids in the compressor to settle. Before using the ice maker for the first time, please wait 2
hours after the unit has been leveled and positioned in its proper place.
Please ensure the ice maker is level and on a stable table or other flat, horizontal surface to
prevent malfunction.
The machine must be placed on a dry and level surface with sufficient ventilation, far from heat
sources, such as ovens and heaters, and from corrosive gases. Leave a clearance of 8 in. (20 cm)
on all sides of the ice maker for proper ventilation. Room temperature should be between 50°F and
100°F.
Do not fill the water tank with hot water. This my damage the ice maker. Use only lukewarm or
cold water.
BEFORE FIRST USE
PREPARING YOUR ICE MAKER
Remove the exterior and interior packaging.
Make sure that the ice basket and ice scoop are inside. If any parts are missing, please contact our
customer service.
Remove the tape holding the ice scoop and ice basket.
Clean the tank and ice basket with warm, soapy water and a soft cloth.
Allow 1 hour for the refrigerant fluid to settle. Then plug the ice maker into a grounded wall outlet.
Note:
06
To Next Page
Loading...
