INTERIOR CLEANING
Tips & Maintenance
16
For Ice Storage Bin
The ice storage bin should be sanitized occasionally. Clean the bin before the ice maker is used for the
first time and reused after stopping for an extended period of time. It is usually convenient to sanitize
the bin after the ice making system has been cleaned, and the storage bin is empty.
The ice scoop should be washed regularly. Wash it just like any other food container.
ICE MAKING PARTS CLEANING
During the using, periodically to clean these main system of your ice-maker.
NOTICE: Stainless steel models exposed to chlorine gas and moisture, such as in areas with spas or
swimming pools, may have some discoloration of stainless steel. Discoloration from chlorine gas is
normal.
DO NOT use solvent cleaning agents or abrasives on the interior. These cleaners may transmit taste to
the ice cubes, or damage or discolor the interior.
WARNING：
Disconnect power to the unit.
Open the door and with a clean cloth, wipe down the interior with a sanitizing solution made of 28g
of household bleach or chlorine and 7.5L of hot water (95T to 115°F).
Rinse thoroughly with clear water. The wastewater will be drained out through the drainpipe.
Reconnect power to the unit
Repeat the above step to clean the water tank and other inner parts of the unit especially, to the water
dividing pipe on the evaporator, when the compressor and the water pump run normally. However, if
there is no water flowing out from the water dividing pipe or the water flowing is very small, please
discharge this water dividing pipe to clean carefully. Clean each little hole on the water dividing pipe
displayed in the following illustration, and make sure each hole is not clogged by something, then
install back to the original location.
When there are ice cubes on the surface of the evaporator, but can’t fall down easily. Never use the
mechanical substance to remove it by force. Only press the "ON/OFF" button for more than 5 seconds
and the unit will enter the ice melting process, after some while, the big ice-cubes will fall down, then
turn off the unit and unplug the power cord to clean the surface of the evaporator.
To Next Page
