Eumig Automatic P8 - Rewinding

Fig, 21
Fig. 22
Rewinding
is a very simple and speedy operation with the EUMIG P 8
AUTOMATIC as the projector has power rewind. You will
find this a great blessing with the large 400 ft. reels.
When the trailer has compleiely run through, lead the film
directly from the take-up to fhe feed spool and fix it to the
latter. Then turn lever D as far Forward as it will ga, which
couples the rewind mechanism, and the film will be rewound
auickly. When rewinding is almost complete, it is advisable
to reduce the speed by means af the motor speed control.
For rewinding, switch A must be set to “Forward", Should vyau
have set it to "Reverse" by mistake and switched on the
rewind mechanism, the projectar matar will run, but the take-
up spool will not revolve,
If you desire to rewind before the whole af the film has been
projecled, take off the automatic threader, open the film
gate, gently remove the film therefrom, ond disengage from
the feed and take-up sprorkets by pressing the spots
marked "x”, Only fhen is it possible to proceed with rewind-
ing as described above,