Maintenance of Self-Emptying Base
Empty as soon as dirt reaches the MAX
mark. Remove the dust cup by moving it
vertically upwards.
1.
Hold the dust cup over a bin. Press the
lower dust cup release tab and empty
the trash into the bin.
2.
Take out the sponge filter and the
cyclone (use the handle) as shown in
figure.
2.
Close the tab, and place the dust cup straight
down back into the self-emptying base.
3.
How to empty the dust cup
Press the upper release tab to open the
top of the dust cup.
1.
How to clean the cyclone
Rinse the cyclone with clean water and
make sure it is completely dry before
putting it back.
Note: Do not use detergents, polishes or
air fresheners to clean the dust cup and
cyclone to avoid corrosion.
3.
Place the cyclone and sponge filter
back down into their regular positions.
Close the dust cup so it clicks into
place.
4.
Place the dust cup back into the
self-emptying base.
5.
To Next Page
Loading...
