15
INSTALLATION
The panels of the adjacent cabinets must be made of heat resistant material.
In particular, cabinets with a veneer exterior must be assembled with glues
which can withstand temperatures of up to 75°C.
In compliance with current safety standards, contact with the electrical
parts of the oven must not be possible once it has been installed.
All parts, which ensure the safe operation of the appliance,
must be removable only with the aid of a tool.
To fasten the oven to the cabinet, open the door of the oven and attach it by
inserting the 2 wood screws into the 2 holes located on the perimeter of the frame.
Electrical connection
• The appliance is usually supplied fitted with a power cord and 3 pin plug.
Install the cooker so that the plug is easily accessible. Plug the 3-pin plug
into a properly earthed, 15A general purpose power outlet preferably on
a separate dedicated circuit. The supply cable should be positioned so that
it does not reach a temperature of more than 75°C along its entire length.
• If the appliance is not supplied with a plug or if connecting the cable directly
to the mains, connection to the electricity supply must be made by an authorised
person in accordance with the Wiring Rules AS/NZS3000. The installation must include
a suitable isolating switch with a minimum contact opening of 3mm between the
appliance and the mains. The isolating switch should be sized according to the load
on the data label and should comply with current regulations (the earth wire should
not be interrupted by the circuit breaker).
To Next Page
Loading...
