EVA EVAstream - 7 Check before; Check before Using the Evastream; Decommissioning; 8 Disposal

EVAstream Mounting - Installation EVAstream Mounting - Installationwww.evaoptic.com30 31
7 Check before
7.1 Check before switching on the EVAstream
The machine and the basin in which it is placed must be completely free of obstacles (small and
large) before the machine is switched on.
The EVAstream machine may only be operated underwater. Always fully submerge the machine
before use. Serious and permanent damage to the machine can occur if the EVAstream is not
submerged during use.
7.2 Check before using the EVAstream
Always read the included user manual before using the machine. The user manual is also published
online at www.evastream.nl.
7.3 Maintenance and repairs
The EVAstream comes equipped with a connection cable with plug. If the EVAstream is permanently
connected to 230V mains, the installation must also be equipped with a main switch/isolation
switch in the space where the Motor Control Unit is installed. During maintenance and work, this
switch must be used to de-energise the installation.
In the space where the swimming pool with EVAstream is located, an on/off switch must be mounted
for the user (in case of a permanent connection to 230V mains). Users should use this on/off switch
to turn on the machine right before use and turn it off immediately after use.
Never open the turbine. Any form of maintenance or repair must be carried out at the factory of EVA
Tech B.V. In case of an established defect, the machine must be dismantled and transported to the
EVA Tech B.V. factory in the Netherlands in agreement with the supplier.
Any attempt to open the machine will cause permanent and irreparable damage. Warranty expires
immediately after any attempt to open the machine.
8 Disposal
8.1 Decommissioning
Electrical shock hazard. Risk of electric shock and injury. Make sure to disconnect the product from
the mains cable before decommissioning.
1. Switch off the power.
2. Switch off the power around the swimming pool.
3. Disconnect the mains cable.
4. Disconnect all other cables.
8.2 Disposal
Before disposing of the different materials, separate them into recyclables, normal waste and special
waste. Comply with local legal regulations and provisions when disposing the product and the
individual components. A product marked with the WEEE symbol must be sent for separate collection
of electrical and electronic devices. Contact your supplier for more information.
6
WARNING