Ensure the device is placed on the flat horizontal surface first.
FILLING WITH WATER
1. Slide the water reservoir up.
(DO NOT hold the water tank by its removable cover to avoid it de-
taching and falling down!)
2. Open the lid and fill the reservoir with water.
3. Place the reservoir back onto the base. Make sure it is installed
properly. The water will start flowing automatically.
Depending on the air temperature and humidity, the full reservoir
should provide from 3 to 8 hours of uninterrupted cooling.
TIP: To extend the time period before the next refill, you need to fill
up the reservoir, wait until the cartridge is full of water (max.10 minutes)
and then refill the reservoir once again.
OPERATING
4. Use a laptop or PC/power bank/adaptor plugged into the socket
as a power source. 2A 5V is a minimum requirement.
5. The device will switch on. Push the screen on top of the device
to enter the menu.
TO START THE DEVICE
FOLLOW THE STEPS
1.
4.
3.
5.
2.
7 8
6. Use the screen and control wheel to navigate through the menu
and adjust the airflow and other features.
7. Move the front grills to adjust the airflow direction.
The temperature of the outgoing air will start to decrease in a few
minutes.
2A 5V
6. 7.
ENJOY YOUR
PERSONAL
MICROCLIMATE!
To Next Page
Loading...
