EasyManuals Logo

EVC BDM100 User Manual

EVC BDM100
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
EVC electronic GmbH -21- BDM100 Module
Interconnections for Siemens PPD1.1 ECUs
Pict. A: The main connector of the Siemens PPD1.1 ECU.
On the Siemens PPD1.1 ECU the power
distribution is provided by the pins of the
main connector as shown in picture A.
Use separate wires to connect GND and
+12Vcc to the pins of the main connector
shown in picture A
Now place the BDM144 probe into the
positioning frame and carefully center the
tips of the spring contact probes on the
BDM-pads on the board as shown in
picture B.
Then connect the BDM110 flat wire cable to
the BDM100 module which is already
connected to your computer.
The tips of the spring contact probes should
reach a spring travel of 1mm minimum for
good contact conditions.
If you then applying power to the main
connector of the ECU the red LED on the
BDM144 probe lights up to indicate that the
logic on the board is supplied with the
required voltage
The BDM100 module is now operational.
Pict. B: This are the pads which are required for the
BDM interface.
Pict. C: In this case the BDM144 probe is best
suited for contacting the BDM-pads on the PPD1.1.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EVC BDM100 and is the answer not in the manual?

EVC BDM100 Specifications

General IconGeneral
BrandEVC
ModelBDM100
CategoryControl Unit
LanguageEnglish