EVC electronic GmbH -6- BDM100 Module
Interconnections for Bosch ECUs using a BDM120 Cable
For connecting the BDM100 module to
the EDC16 or to the ME9 ECUs the
BDM120 cable is required which is
equipped with an own power supply
First solder the 12way pin header onto
the pads for the BDM port of the EDC16
or ME9 board (picture A).
Note that at all only 10 pads of the total
14 pads are used for the EDC16 or ME9
programming port.
Now take the BDM110 cable and connect
it with the BDM120 cable as shown in
picture B.
Then connect the other side of the
BDM100 cable to the BDM100 module.
Ensure that you have plugged the 12way
connector in the 12way header exactly
as shown in picture B!
Again, ensure that all connections are
plugged in the right direction.
Finally, the power supply of the BDM120
cable is plugged into the power source
connector (picture C).
The upper of the two blue LEDs on the
front panel should light up to indicate, that
the ECU board is now supplied with the
required voltage.
The BDM100 module is now operational.
After finishing your work always remove
the power supply from the power plug
connector first before disconnecting any
other connection!
Pict. A: This is the way the pin header will soldered..
Pict. B: The direction the BDM120 must plugged!
Pict. C: Finally the power will applied.
To Next Page
Loading...
Need help?
General