Even Embers GAS2420AS

Questions and Answers

J
Jennifer BowersAug 15, 2025
How to fix Even Embers Grill burner that will not light?
- T
  Thomas JensenAug 15, 2025
  If the burner on your Even Embers Grill won't light, start by checking that the LP gas tank valve is open and securely attached. If the tank is low or empty, replace or refill it. Also, inspect for any gas leaks, following the “Leak Testing” instructions. Obstructions in gas flow can also prevent lighting, so clean the burner assembly and check for bent or kinked hoses. Ensure the burner is properly seated and that the venturi is clear of spider webs or insect nests. Clogged burner ports should be cleaned, and a dead battery should be replaced. Finally, cooking residue on wires or electrodes should be cleaned with rubbing alcohol, and any wet components should be wiped dry.
E
Erica JonesAug 18, 2025
Why is my Even Embers GAS2420AS not getting hot enough?
- G
  Gregory PageAug 18, 2025
  If your Even Embers Grill isn't getting hot enough, the first thing to check is whether you are out of gas. If so, replace or refill the LP gas tank. If that's not the issue, a flow limiting device may have been activated. Try a mini reset by turning the control knobs and LP gas tank valve to “OFF”, waiting one minute, and then relighting the grill per the “Lighting Instructions”. If the flames are still too low, perform a full reset: Turn everything off, disconnect the regulator from the propane tank, inspect the LP cylinder rubber seal, wait one minute, reconnect the regulator, perform “Leak Testing” on all connections, and then light the grill per the “Lighting Instructions”.
I
imorseAug 21, 2025
What to do if my Even Embers Grill has a flare-up?
- M
  Mr. Christian SteeleAug 21, 2025
  Flare-ups on your Even Embers Grill can occur due to grease buildup. Clean all grill parts according to the “Proper Care and Maintenance” instructions. Excess fat in meat is another common cause, so trim fat from meat before grilling. Finally, excessive cooking temperature can also lead to flare-ups; adjust the cooking temperature to a lower setting.
T
Tiffany BaldwinAug 25, 2025
What to do if my Even Embers GAS2420AS Grill has a grease fire?
- E
  Emily BerryAug 25, 2025
  A grease fire on your Even Embers Grill is often caused by grease trapped by food buildup around the burner system. If this happens: 1. Turn control knobs and the LP gas tank valve to the “OFF” position. 2. Leave the lid either open or closed and allow the fire to burn out. If necessary, use a BC type fire extinguisher, baking soda, sand, or dirt to smother the fire. 3. After the grill cools down, remove and clean all parts following the “Proper Care and Maintenance” instructions.
A
Amy ForbesAug 28, 2025
Why is the flame on my Even Embers Grill yellow or orange?
- S
  Shelly ThompsonAug 28, 2025
  If the flame on your Even Embers Grill is yellow or orange, it could be due to a few reasons. If it's a new burner, it may have residual manufacturing oils; burn the grill for 15 minutes on “HIGH” with the lid closed. Spider webs or insect nests in the venturi can also cause this issue, so clean the venturi and burner assembly. Food residue or grease buildup can also affect the flame, so clean the burner assembly. Lastly, poor alignment of the valve to the burner venturi can be the culprit; ensure the burner venturi is properly engaged with the valve.
G
Gregory ThomasAug 31, 2025
Why does my Even Embers Grill have an irregular flame pattern?
- K
  Kayla RichardsonSep 1, 2025
  An irregular flame pattern on your Even Embers Grill, where the flame does not run the full length of the burner, is often due to clogged or blocked burner ports. Clean the burner ports to resolve this. Another potential cause is that the air shutter on the burner needs adjustment. Refer to the “Burner Adjustment” section for instructions.
A
ahoSep 4, 2025
Why does the flame keep blowing out on my Even Embers GAS2420AS?
- R
  robertserinSep 4, 2025
  If the flame on your Even Embers Grill blows out, it could be due to high or gusting winds; avoid using the grill in such conditions. Another reason could be that you're low on LP gas; replace or refill the LP gas tank. Obstructions in the burner holes can also cause this; refer to the “Burner Assembly/Maintenance” instructions. Lastly, a tripped flow limiting device might be the issue; refer to the “Regulator Resetting Procedure”.
S
sandersisabelSep 7, 2025
Why is my Even Embers GAS2420AS having flashback or melting knobs?
- M
  Monica MartinezSep 7, 2025
  Flashback (fire in burner tubes) or melting knobs on your Even Embers Grill usually indicates that the burner and/or burner tubes are blocked. To resolve this, clean the burners and/or burner assembly.
H
Heidi HowardSep 10, 2025
Why is the inside of the lid peeling on my Even Embers GAS2420AS Grill?
- R
  Robert StewartSep 10, 2025
  If the inside of the lid on your Even Embers Grill is peeling, resembling paint peeling, it's likely due to baked-on grease buildup that has turned into carbon and is flaking off. To fix this, clean the grill thoroughly following the “Proper Care and Maintenance” instructions.

Summary

IMPORTANT SAFETY WARNINGS

IF YOU SMELL GAS

Steps to take if you detect a gas smell, including shutting off gas and extinguishing flames.

GENERAL HAZARD WARNINGS

Warnings about storing flammable liquids, LP cylinders, and general safety precautions.

LP CYLINDER STORAGE DANGERS

Specific dangers related to storing LP cylinders, including overfilling and placement.

GENERAL WARNINGS

LP GAS CYLINDER (TANK) SPECIFICATIONS AND INSTALLATION

LP Gas Cylinder Specifications

Details on the required size, capacity, and markings for LP gas cylinders used with the grill.

Filling the LP Gas Cylinder

Guidelines for safely filling LP gas cylinders, including capacity limits and professional filling.

LP Gas Cylinder Rubber Seal Inspection

Instructions for inspecting the rubber seal on the propane tank valve for damage before use.

Installing the LP Gas Cylinder

Step-by-step process for securely placing and connecting the LP gas cylinder to the grill.

HOSE & REGULATOR SPECIFICATIONS AND INSTALLATION

Connecting Hose and Regulator

Detailed steps for attaching the regulator to the LP gas cylinder and ensuring a secure connection.

Regulator Resetting Procedure

Steps to reset the flow limiting device if the grill is not heating properly.

LEAK TESTING

WHEN TO PERFORM A LEAK TEST

When to conduct leak tests, including after assembly, refilling, or moving the grill.

CHECKING FOR LEAKS

Step-by-step procedure to identify gas leaks using a soap and water solution.

PRE-START CHECK LIST

GAS LIGHTING INSTRUCTIONS

Lighting the Main Burners

Step-by-step instructions for igniting the primary burners on the grill.

Lighting the Side Burner

Instructions for lighting the auxiliary side burner on the grill.

OPERATING THE GRILL

BREAKING IN YOUR GRILL

Initial steps to prepare the grill for first use by burning off manufacturing oils.

PREHEATING THE GRILL

Recommendation to preheat the grill before cooking to ensure desired grilling surface temperatures.

CONTROLLING FLARE-UPS;GREASE FIRES

Methods to manage and extinguish grease fires and minimize flare-ups during cooking.

ROTISSERIE COOKING

TURNING OFF THE GRILL

USING OTHER FEATURES OF THE GRILL

THE SIDE BURNER

Information on using the side burner for cooking side dishes and warming sauces.

PROPER CARE & MAINTENANCE

CLEANING INTERIOR OF GRILL

Instructions for cleaning food residue and ash from the grill's interior after use.

MAINTAINING EXTERIOR OF GRILL

Steps for cleaning and protecting the grill's painted, stainless steel, porcelain, and plastic surfaces.

RUST

Causes of rust and methods to prevent or remove it, along with cleaning precautions.

BURNER ASSEMBLY;MAINTENANCE

TRANSPORTING AND STORAGE

BEFORE STORING YOUR GRILL

Steps to take before storing the grill, including cleaning and cylinder disconnection.

TROUBLE SHOOTING

GRILL COOKING TIPS

CLEANLINESS

Food safety practices for handling raw and cooked foods and utensils.

GRILLING TO PROPER TEMPERATURE

Recommendations for using a meat thermometer to ensure food reaches safe internal cooking temperatures.

ASSEMBLY INSTRUCTIONS

PARTS LIST

An enumeration of all parts included with the grill for assembly.

Assembly Steps Overview

Key stages and instructions for assembling the gas grill, covering various components and their connection.

WARRANTY