42 43
SafeZone
TM
Load Leg Storage
To remove load leg,
open the user guide
storage compartment and
push the button inside the
compartment while pulling
the leg out of the front of
the base.
Note: When not using the
load leg, it should be stored
in the load leg storage area
under the base or removed
from base. Preferred under
the base.
Fold and store away from
children in a place where it
cannot be damaged.
To store load leg when you
are not using it, push the
button on the lower portion
of the load leg, slide the
lower portion back up until it
locks into place, then rotate
back into the stored location.
The tab on the load leg foot
is pressed into a slot in the
storage location on the base.
And it locks into position.
To store under base, reverse
steps on page 40.
CLICK!
Although we recommend using the base with
the load leg, in some cases it may not be
possible. If it is not possible you should store
or remove the load leg. Refer to page 43
for removing the load leg from the base. To
store load leg, follow steps below.
SafeZone
TM
Load Leg Removal
To Next Page
Loading...
