EasyManua.ls Logo

Evenflo Gold SECUREMAX - Installing Base with Vehicle Seat Belt; Seat Belt Installation Procedure

Evenflo Gold SECUREMAX
63 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
106 107
The Federal Aviation Administration (FAA)
recommends that you secure your child for air travel
in an appropriate child restraint based on your
child’s weight and size. Turbulence can happen with
little or no warning. When turbulence occurs, the
safest place for your child is in a properly
installed child restraint, not in an adult’s
lap or on the aircraft seat with its seat belt.
Keeping your child in a child restraint during the
flight will help ensure your family arrives safely at
your destination.
The FAA recommends that a child weighing:
more than 18 kg (40 lbs) use an aircraft seat belt;
less than 9 kg (20 lbs) use a rear-facing child
restraint; and
from 9 to 18 kg (20 to 40 lbs) use a forward-
facing child restraint.
Please note that these FAA recommendations
may vary from those applicable to the use of
your child restraint in a motor vehicle.
Securing Your Child Restraint in Aircraft
CR2032
CR2032
2
1
4
5
a
b
b
c
4.
Turn the male side of the Chest Clip over and loosen screws
with a small Phillips screwdriver. Remove the cover
a
.
5. Remove Circuit Board
b
from Chest Clip. Remove
Battery
c
from Circuit Board. Replace Battery with new
Panasonic
TM
CR2032 Lithium button cell Battery, as
shown.
6. Place the Circuit Board with the new Battery in the
Chest Clip. Replace the Cover and tighten the screws.
This completes the battery replacement process.
If you have questions, please contact
Evenflo’s ParentLink
at:
1-800-233-2229 in the (U.S) and (Canada)
,
or online
at: www.evenflogold.com or www.evenflogold.ca
USING SENSORSAFE
TM
(CONT.)
Registered trademarks referenced in this manual are the
property of their respective owners.

Related product manuals