104 105
REPLACING THE SENSORSAFE
TM
CHEST CLIP
BATTERY.
1. Loosen Harness by pressing Harness Release Button on
the front of the Child Restraint and pulling forward on
both Harness Straps.
2. Unbuckle Harness by pressing the button on the Crotch
Buckle and pulling out both Buckle Tongues.
3. Open Chest Clip by pressing the Release Button and
pulling the Chest Clip apart.
PLACE AT ARMPIT LEVEL
SENSOR
SAFE
PLACE AT ARMPIT LEVEL
SENSOR
SAFE
PLACE AT ARMPIT LEVEL
SENSOR
SAFE
1
2
3
USING SENSORSAFE
TM
(CONT.)
3. CYCLE THE SENSORSAFE
TM
CHEST CLIP.
Your SensorSafe
TM
Chest Clip is designed
to “go to sleep” if clipped for more than
12 hours. To reset, or “wake up” the
chest clip, unfasten then re-fasten it.
When you do this, the blue LED will flash
two times.
TO PRESERVE BATTERY LIFE,
ALWAYS STORE THE SENSORSAFE
TM
CHEST CLIP IN THE
UNCLIPPED POSITION.
4. DRIVE THE VEHICLE.
The SensorSafe
TM
Receiver is designed to respond after the
vehicle has been driven at 5 miles per hour or more.
5.
PARK THE VEHICLE AND TURN OFF THE IGNITION.
Within 2 seconds of parking your vehicle and turning
off the ignition you will hear the SensorSafe
TM
reminder,
alerting you that your baby is in the vehicle. If you
don’t hear the reminder tone, test your SensorSafe
TM
by
following steps 1-5 again. Contact Evenflo’s ParentLink
at: 1-800-233-2229 in the (U.S) and (Canada), or online
at: www.evenflogold.com or www.evenflogold.ca if the
reminder tone again fails to sound.
Note: SensorSafe
TM
Receiver will also alarm if your child
unclips the Chest Clip after the vehicle has been driven at
5 miles per hour or more, but only if the vehicle is on.
PLACE AT ARMPIT LEVEL
SENSOR
SAFE
USING SENSORSAFE
TM
(CONT.)
To Next Page
Loading...
