EasyManua.ls Logo

Evenflo Gold SECUREMAX - Page 52

Evenflo Gold SECUREMAX
63 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
102 103
1. INSTALL THE SENSORSAFE
TM
RECEIVER.
Locate the 16PIN OBDII port
a
in your vehicle. Refer
to your vehicle owner’s manual for location. Plug in the
SensorSafe
TM
Receiver.
2. POWER UP THE VEHICLE.
If unable to locate your vehicle
manual, the SensorSafe
TM
Application may contain
information regarding the
location of the 16PIN OBDII port
for your vehicle
Your SensorSafe
TM
Receiver will
sound one prolonged tone
when it first communicates with
the vehicle network. In some
vehicles this occurs immediately
after installing the SensorSafe
TM
Receiver, in other vehicles the
tone will not be heard until the
vehicle has been started.
This initialization signal only
occurs one time after installation.
a
USING SENSORSAFE 2.1
USING SENSORSAFE 2.1USING SENSORSAFE
TM
GENERAL INFORMATION ABOUT SENSORSAFE
TM
(CONT.)
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Chest Clip:
RF warning statement:
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure
condition without restriction.
Receiver Plug:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance
20cm between the radiator & your body.

Related product manuals