46 47
• This lower anchor connector assembly is intended
to be used ONLY as described in these instructions.
Serious injury or death may result from misuse.
• In addition to these instructions, read and follow your
vehicle owner’s manual regarding installation of the
child restraint and LATCH. If there is a discrepancy,
follow your vehicle owner’s manual.
• ONLY use for securing base to vehicle lower anchor
bars.
• NEVER attach two lower anchor assembly
connectors to one vehicle lower anchor bar.
• NEVER use the vehicle seat belts when using the
lower anchor connector assembly. Using both
together can cause slack in a sudden stop or crash.
• When not in use, the lower anchor connector
assembly should be securely stored in the storage
area located under the convenience base or on the
side of the base (p 93). Keep out of reach of children.
Installing the Base with the Lower Anchor
Connector Assembly
• ALWAYS be sure that the lower anchor connectors
are fully engaged onto the vehicle lower anchor
bars by pulling hard on the lower anchor connector
assembly harness. If they are not totally engaged,
the lower anchor connector assembly system will not
secure your child restraint. Serious injury or death
may result.
• DO NOT use this child restraint if it moves more than
2.5 cm (1 in.) side-to-side or front to back at the
vehicle belt path. Serious injury or death may result
from poor installation. If you can not tightly secure
the child restraint, try again or move it to another
location.
• This child restraint MUST face the rear of the vehicle.
• The carrier MUST be locked firmly into the base.
Check by lifting up on the carrier.
• NEVER use this child restraint in the forward-facing
position.
Installing the Base with the Lower Anchor
Connector Assembly (cont.)
WARNING!
DEATH or SERIOUS
INJURY can occur.
WARNING!
DEATH or SERIOUS
INJURY can occur.
To Next Page
Loading...