110 111
Installing Carrier WITHOUT Base in Aircraft
(cont.)
PLACE AT ARMPIT LEVEL
SENSOR
SAFE
Fasten the aircraft seat belt.
Installing Carrier WITHOUT Base in Aircraft
(cont.)
4
PLACE AT ARMPIT LEVEL
SENSOR
SAFE
The aircraft seat belt must be as tight as possible.
Route the excess seat belt strap back through the
belt slots, as shown above. Using your full weight,
push the child restraint firmly onto the aircraft seat
while pulling on the excess seat belt strap to tighten.
Check your work. Try to move the child restraint
in all directions. If you can move the child restraint
more than 2.5 cm (1 in.) side-to-side or front to
back at the belt path, the aircraft seat belt is not
tight enough, and you MUST install again until the
seat belt is tight.
5
To Next Page
Loading...